Geared DC Motor with Magnetic Encoder Outputs - 7 VDC 1:20 Ratio Shipping:2-4 Weeks We added some extra goodies

We added some extra goodies to make this GPS FeatherWing better than a breakout: a FET-driven ENABLE pin so you can turn off the module using any microcontroller pin for low power use

You can use your micro:bit for all sorts of unique creations

the Typical Efficiency and Output Current section below shows how the achievable continuous output current depends on the input voltage)

Because its address is changeable

or 8 wire stepper motors

Geared DC Motor with Magnetic Encoder Outputs - 7 VDC 1:20 Ratio Shipping:2-4 Weeks We added some extra goodiesThe first step in a robotics project is to get a motor spinning. Once you've done that, you quickly learn that not all motors go the same speed, even if they are the same part number! There are always variations that relate to voltage, environment, and manufacturing changes. So, the second step is to figure out how fast it's going! Turns out that's not so easy, but the best way to get started is to add an encoder wheel and an optical or magnetic