Stepper Motor with Cable Category_Communication/Ethernet * OD - 1\"

* OD - 1\"

which makes the new color data take effect (note: it is possible for low pulses as short as 40 μs to trigger a reset)

so you can connect more sensors

* Voltage: 4

These are used where the burst has been transmitted by another sonar

Stepper Motor with Cable Category_Communication/Ethernet * OD - 1\"This is a simple, but very powerful stepper motor with a 4 wire cable attached. This is a [Bipolar](http: en. wikipedia. org wiki Bipolar_electric_motor) Motor. **Features:** * Step Angle (degrees) : 1. 8 * 2 Phase * Rated Voltage: 12V * Rated Current: 0. 33A * Holding Torque: 2. 3kg*cm * 5mm Diameter Drive Shaft * Winding resistance: 32. 6 * Winding inductance: 48 mH * Max flux linkage: 1. 8 Vs * Maximum Detent Torque: 0. 016 NM * Total inertia (kg.