SparkFun Current Sensor Breakout - INA169 SF_Educators com/sparkfun/SparkFun_u-blox_GNSS_v3) to make reading and

com/sparkfun/SparkFun_u-blox_GNSS_v3) to make reading and controlling the MicroMod GNSS Function Board over the MicroMod\'s I2C bus it's easy

Make the I/O line an input (high impedance)

The SARA-R5's UART interface can be configured into one of five variants

one for Sub-GHz wideband Nagoya NA-773 telescopic antenna included and another 2

The open-source IDE can be downloaded for free (currently for Mac OS

SparkFun Current Sensor Breakout - INA169 SF_Educators com/sparkfun/SparkFun_u-blox_GNSS_v3) to make reading andThe INA169 is a high side current monitor, which means that you place a resistor (a shunt resistor) on the positive power rail and the INA169 measures the voltage drop across that resistor. The INA169 outputs a small current based on the measured voltage drop. If you place a resistor from the output of the INA169 to ground, you can measure the voltage at the output. Input common mode and power supply voltages are independent and can range from 2. 7V